HVAC Repair in Newton, IA
Homes here need heat from October through May and cooling from June through August. If your system quits, tell us what it's doing and a licensed contractor who covers Jasper County will get in touch.
Tell us about the job
It takes about a minute.
Eleven months of work a year on your system
Your furnace runs October through May here, eight months out of the year. On winter nights that average 16°F, it cycles on and off for hours to hold the house steady, and every one of those cycles depends on the igniter lighting the burner. When it wears out, the furnace won't fire at all.
Summer is shorter, just June through August, but afternoons averaging 83°F still put real hours on the condenser outside. Jasper County has seen 20 winter storms and 39 damaging wind events over the past ten years, and storms mean power drops. Most furnaces and air conditioners come back on by themselves once power returns. If yours doesn't, that's worth a call rather than a wait.
- 8 months
- October through May, your system heats
- 3 months
- June through August, it cools
- 16°F
- the average winter night it heats against
- 83°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
A new furnace and air conditioner would cut about $120 a year off heating and cooling for a typical Jasper County home.
Estimates for a typical Jasper County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Iowa fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed.
Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.
Iowa requires HVAC contractors to hold a state license.
Iowa's Plumbing and Mechanical Systems Board issues this license and keeps the record of who holds one. The license belongs to the contractor, not to any one job, so the same license that qualifies them to repair your furnace or air conditioner covers the rest of their HVAC work across the state.
For a heating and cooling repair, that license is what stands behind the work. There is no separate check for this one job. The state's record of who is licensed, and who is not, is the protection you have here.
Sources: Iowa Legislature · Iowa Department of Inspections, Appeals and Licensing
- Why is my heat not working?
- Start with the thermostat and the power to the furnace. If the display is blank, check the breaker and any switch that looks like a light switch near the unit, since that shuts the furnace off too. Gas furnaces also need a pilot light or igniter to fire, so if the blower runs but no heat comes out, that's usually where to look. At 16°F on a winter night here, a furnace that won't start needs attention fast, so if the basic checks don't get it going, call for a repair.
- Why is my system running but not cooling the house?
- The most common cause is a dirty filter or blocked vents keeping cold air from moving through the house. Check the filter first and swap it if it's gray or clogged, then make sure furniture or rugs aren't covering any vents. If the air coming out feels warm rather than just weak, the problem is likely with the refrigerant system itself, and that's a job for a contractor. Summer afternoons here average 83°F, so a system that's running constantly without cooling the house needs a look before it has to work through a full heat wave.
- What can I check before calling for HVAC repair?
- Check the thermostat settings first, since a battery change or a setting bumped to the wrong mode causes more no-heat and no-cool calls than people expect. Check the breaker box and any power switch near the furnace or outdoor unit. Check the filter and replace it if it's dirty, since a clogged filter can stop a system from heating or cooling properly. If everything checks out and the system still isn't working, a licensed contractor can diagnose what's actually wrong.